8
q DOOR HEATER 8
w DOOR HEATER OFF pq ON 8 Switching door heater on and off for appliances with
glass doors. (see Chapter “
Heater
”)
q ALARM TEST 8
w ALARM TEST ACTIVATION 8
w ALARM TEST 8 This function is used for simulation a temperature alarm
situation of the refrigerator. Pressing the ENTER-button
will launch the following alarm test cycle:
1. Phased increase of the internal temperature until the
upper alarm limit is reached. Triggering of the
temperature alarm.
2. Phased reduction of the internal temperature until
the lower alarm limit is reached. Triggering of the
temperature alarm.
q ALARM TEST 2 8 The same functions as described above for the freezer
unit in combination appliances.
q REMOTE ACTIVATION 8
w REMOTE OFF pq ON 8 The remote alarm function can be switched on and off
for an alarm test.
q COMM. ADDRESS 8
w COMM. ADDR: 0 pq 255 8 With the aid of the built-in RS485 interface several
appliances can be networked with each other. If this is
the case every individual appliance must receive a
separate communication address.
(setting of 0 – 255)
q SERVICE 8
w RESET SERVICE TIME 8
w RESET COUNTER 8
w YES pq NO 8 After the expiry of a given operating time a “SERVICE”
message appears on the display to call attention to the
fact that a regular maintenance is due. The counter for
this service time can be put back with this function.
q HIDE SERVICE WARNING 8 This function is for cancelling the “service”
message.
q USER PASSWORD 8 Changing the password to access the “SETTINGS”
MENU.
w CHANGE USER PASSWORD:
0XXX
XXXX 8 Enter the new password twice and confirm.
q CALIBRATION 8 This function is for calibrating the sensors. As each
setting in the calibration compromises the function of
the appliance, this function is protected by a password
in the factory and must only be used by trained service
staff!
w CALIBRATION PASSWORD:
0XXX 8 Enter the password to the calibration menu
To Next Page
Loading...
Need help?
General
