Using the appliance PLB40
10
Switching the display on
➤ Press the power button (fig. 2 1, page 7) briefly to switch on the display.
Switching off the lithium iron phosphate battery pack
The battery pack switches off automatically after 24 hours if no load and no charger
are connected.
➤ Press the power button (fig. 2 1, page 7) for at least 3 seconds to switch the
device off.
✔ The device emits 1 beep.
✔ The display switches off.
6.3 Charging the lithium iron phosphate battery pack
!
➤ Place the lithium iron phosphate battery on a firm base.
Charging with the power supply unit
➤ Connect the power supply unit to the connection socket (fig. 2 8, page 7).
➤ Connect the power supply unit to the AC mains.
✔ The symbol lights up.
✔ The display shows the charging status.
Charging with the smart alternator, 12 V accessory socket or solar panel
➤ Connect the charge cable to the connection socket (fig. 2 9, page 7).
➤ Connect the DC plug to the DC inlet Anderson socket on battery side.
✔ The symbol lights up the battery state of charge as a percentage.
✔ The display shows the charging status.
WARNING! FIRE AND/OR EXPLOSION HAZARD.
Lithium iron phosphate batteries that are charged with too high voltage
can ignite. Use 8 to 25 V input voltage to charge the battery pack.
DometicPLB40_OPM_4445102605_APAC(en)_20xx-xx-xx.book Seite 10 Mittwoch, 2. Dezember 2020 9:02 09
To Next Page
Loading...
