Troubleshooting RCD10.5
24
7.1 Error and warning indication
All faults are indicated by a warning symbol, a fault ID and a beep. The beeping lasts
for 2 minutes and is repeated every 30 minutes until the error has been rectified.
RCD10.5ET, RCD10.5XET
Faults are indicated by a fault code with a warning symbol ( ) in the middle of the
TFT display.
If multiple faults occur, the fault codes scroll over in the middle of the display.
All faults of the WARNING (W) type are reset automatically once the fault has been
rectified.
All faults of the ERROR (E) type must be reset manually:
➤ Press the control knob for at least 2 seconds.
✔ A beep sounds.
✔ The error has been reset.
The refrigerator is not
cooling adequately.
The ventilation around the cool-
ing unit is not sufficient.
➤ Check that the ventilation grille is
not obstructed.
The evaporator is iced up. ➤ Check whether the refrigerator
door closes properly. Make sure
that the refrigerator seal fits cor-
rectly and is not damaged. Defrost
the refrigerator.
The temperature is set too high. ➤ Set a lower temperature.
The ambient temperature is too
high.
➤ Remove the ventilation grille for a
while so that warm air can escape
quicker.
Too much food was placed in the
refrigerator at the same time.
➤ Remove some of the food.
Too much warm food was placed
in the refrigerator at the same
time.
➤ Remove the warm food and leave
it to cool down before putting it in
again.
The refrigerator has not been
operating for very long.
➤ Check the temperature again after
four or five hours.
Fault Possible cause Suggested remedy
To Next Page
Loading...
Need help?
General
