Cleaning and maintenance RCD10.5
26
8 Cleaning and maintenance
!
A
➤ Clean the refrigerator regularly and as soon as it becomes dirty with a damp
cloth.
➤ Make sure that no water drips into the seals. This can damage the electronics.
➤ Wipe the refrigerator dry with a cloth after cleaning.
➤ Check the condensate drain regularly.
2 Yes E Outer fan overcurrent ➤ Press the on/off
button for at least
2seconds.
3 Yes E Compressor does not start ➤ Press the on/off
button for at least
2seconds.
4 Yes E Compressor overload ➤ Press the on/off
button for at least
2seconds.
5 Yes E Thermal cut out compressor
controller unit
➤ Press the on/off
button for at least
2seconds.
6 No W CI bus fault Resets automatically
– Yes W Door open for more than
2minutes
➤ Close the door.
WARNING! Electrocution hazard
Always disconnect the refrigerator from the mains before you clean and
service it.
NOTICE! Damage hazard
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the refrigerator.
• Never use hard or sharp tools to remove ice or to free objects frozen
onto the device.
• Do not use any mechanical tools or any other tools to speed up the
defrosting process.
Number of
flashes
Audio alarm Fault type Fault Solution
To Next Page
Loading...
Need help?
General
