RF60, RF62 Safety instructions
17
• Only connect the device as follows:
– DC outlet: Only use cables with an appropriate cross section.
– AC outlet: Only use the AC cable supplied
• Never pull the plug out of the socket by the cable.
• If the device is connected to a DC outlet: Only select DC operation
(battery mode) if you are using a battery monitor or if the alternator in
your vehicle provides sufficient voltage.
• If the device is connected to a DC outlet: Disconnect the device or
switch it off when you turn off the engine. Otherwise you may dis-
charge the battery.
• Ensure that the ventilation openings are not covered.
• Do not use electrical devices inside the device unless they are
recommended by the manufacturer for the purpose.
• Do not fill the inner container with ice or fluids.
• Only store heavy objects such as bottles or cans in the device door, in
the vegetable compartment or on the bottom shelf.
2.4 Operating with gas safely
!
WARNING! Failure to obey these warnings could result in death
or serious injury.
Explosion hazard
• Only operate the device at the pressure shown on the type plate. Only
use pressure controllers with a fixed setting which comply with the
national regulations. Use a DIN-DVGW-approved pressure regulator
with a fixed setting in accordance with DIN EN 16129.
• When using gas, the device may only be used outdoors.
• Beware of suffocation!
Operating the device with gas in an unventilated area will reduce the
amount of oxygen in this area.
• Do not operate the device with gas in unventilated areas such as
enclosed premises, tents, motor vehicles, motor homes, caravans,
ships, yachts, boots and truck cabs.
• Never place the device near flammable materials (paper, dry leaves,
textiles).
• Keep flammable objects away from the burner.
• Never store liquid gas cylinders in unventilated areas or below
ground level (funnel shaped holes in the ground).
To Next Page
Loading...
