Dometic RF62 - Page 28

EN
Troubleshooting RF60, RF62
28
In DC mode:
The device is not
working (plug is
inserted).
No voltage is flowing
from the DC power
socket in your vehicle.
The ignition must be switched on in
most vehicles to supply current to the
DC power socket.
The vehicle fuse has
blown.
Replace the vehicle fuse in the DC
socket (usually 15 A) (Please refer to
the operating manual of your vehicle).
In AC mode:
The device is not work-
ing (plug is inserted).
No voltage present in
the AC socket.
Try using another plug socket.
In gas mode:
The device is not
working (to device is
connected to the gas).
The device is not
properly connected to
the gas.
Check if the gas supply is in full
working order.
Check if the valve on the gas bottle is
open.
Check if there is still gas in the bottle.
Check if several energy sources are
connected at the same time.
Hold down the temperature controller
longer to ignite the flame.
The device does not start
up after a long period of
inactivity.
– Disconnect the device from the power
supply
Turn it upside down and wait for
5min.
Turn the device the right way up again
and switch it on again.
Problem Possible cause Suggested remedy