Installation
refer to point 7.0, page 8
Securing
Changing the Sliding Hinge
refer to point 9.0, page 10
Energy Saving Tips
If possible, always store pre-cooled goods.
Do not expose the miniBar to direct sunlight and do not place it close
to a source of heat.
An unobstructed air circulation in the cooling unit must be
ensured (ref. chapter 7.0 Installation).
When removing goods, only open the miniBar briefly.
Switch on the miniBar approx. 12 hours before stocking.
31
23.0
24.0
Drive in the screws and put the caps back on.
The Hipro can be screwed to
the furniture using the fittings
at the bottom.
25.0
26.0
To Next Page
Loading...
