13
Reinstall burner, being careful that the end of the
Check to make sure slots are centered under the
-
burner).
Be sure to reconnect the wire to high voltage
electrode. Check the electrode for proper location
and gap.
Turn on manual gas shutoff valve and check all
Connect 230-240 volt power cord to the outlet and
Check LP gas safety shutoff.
13.
14.
15.
16.
17.
MAINTENANCE & SERVICE
TROUBLESHOOTING
Refrigerator does not cool properly
Burner jet clogged.
Check level of refrigerator.
Venting problem.
Improperly set thermostat.
Burner dirty.
LP gas pressure low at burner.
2,75 kPa at pressure port.)
Burner damaged.
Odour from fumes
•
•
•
•
•
•
•
•
•
•
•
•
•
To Next Page
Loading...
