12
If for
any reason
the gas cock lever has come off position in the driving plastic
disc,
check alignment, Proceed as follows:
1.
Turn
downwards
the driving plastic disc "A" to stop
"B"
(see fig. 13).
2.
Turn
downwards
the lever
"C"
of the gas cock as far as possible (fig, 13).
3.
Pull the driving disc "A" outwards (fig. 14).
.3.
WI
. .
Fig.
13
Fig.
14
4.
Turn
the lever
"C"
of the gas cock into vertical position
"D"
(see fig. 15).
3.
Release the driving disc which is then pulled inwards by spring action, whereby
the lever of the gas cock snaps into its slot
"E"
on the driving disc
"A"
(fig. 16).
iiote:
If
the
gas cock lever
sluggishly
snaps into its position in the driving
disc "A",
adjust the two fastening screws
"F"
of the mechanism.
Fig.
15
Fig.
16
To Next Page
Loading...
