- 17 -
Before starting the refrigerator:
Check that all the manual gas valves are in the ON position.
Make sure that a continuous 12V DC supply is available for
the electronic control to function.
To start the refrigerator:
Press the ON/OFF button. 1.
Select operation mode:2.
•
AC and GAS.
Press the AUTO/GAS - AES/AUTO/GAS mode
selector button (if not already on). The illuminated
lamp indicates the selected mode.
(If the CHECK indicator lamp is illuminated, see
REFRIGERATOR OVERVIEW > MODES OF
OPERATION > AUTO MODE - AES/AUTO MODE for
further information.)
•
GAS operation only.
Press the AUTO/GAS - AES/AUTO/GAS mode
selector button to turn off the AUTO mode (if not
already off).
(Within 45 seconds the burner should be ignited
and operating normally. If not, see
REFRIGERATOR
OVERVIEW > MODES OF OPERATION > GAS MODE
for further information.)
• (3-way models only)
Press the DC mode indicator button. The DC lamp
turn off the DC mode by pressing the DC mode se-
lector button. The DC lamp will then be turned off.
If necessary, adjust the thermostat by pressing the 3.
Temperature selector button.
(
The temperature is controlled by a factory
preset temperature setting.)
DM2652, DM2662, DM2663, DM2852, DM2862, NDM1062 &
NDR1292
Turn the Climate control switch to I (ON).
DM3862, NDM1062 & NDR1292
Press the CLC button. The indicator lamp will
illuminate.
NDM1062 & NDR1292
Turn the Low ambient control switch to I (ON).
DM3862, NDM1062 & NDR1292
Press the LAC button. The indicator lamp will
illuminate.
The refrigerator may be shut off while in any mode of opera-
tion by pressing the main power ON/OFF button to the OFF
position. This shuts off all DC power to the refrigerator, includ-
ing the interior light.
If the refrigerator will not be in operation for a period of weeks,
it should be emptied, defrosted, cleaned and the doors left ajar.
The ice trays should also be dried and kept outside the cabinet.
To Next Page
Loading...
