- 7 -
Be careful when installing the refrigerator models
NDM1062 & NDR1292. These are equipped with the
latest vacuum insulated panel technology. The insu-
lating panels are located on the top, back, bottom,
sides and doors. If the surface is punctured, loss of
insulation will occur, resulting in poor refrigerator
performance.
For a proper installation, follow these instructions:
The refrigerator must be level and installed in a substantial
enclosure.
Do not install the appliance directly on carpeting. Carpet-
ing must be removed or protected by a metal or wood panel
beneath the appliance, which extends at least full width and
depth of the appliance.
must be in place across the up-
per opening of the enclosure. The top frame
of the refrigerator will be anchored to the
wood strip with screws.
When installing the refrigerator in the enclosure, all areas
within the recess have to be sealed. Verify that there is a
complete seal between the front frame of the refrigerator and
-
ing strip is applied to the rear surface of the front frame for
this purpose. The sealing strip should provide a complete
vehicle interior.
and
It is important to follow the sequence in securing refrigerator
in enclosure since failure in doing so can cause leakage be-
storage area or ceiling and top of the refrigerator greater than
1 1/2 inches should be blocked. The heat produced at the rear
of the refrigerator will become trapped in this space, making
refrigerator.
seal at the front frame), the refrigerator is to be secured in the
enclosure with screws (not included).
RM2351 & RM2354
Four screws installed through the front frame. 1.
(To cover the screw heads, use the plugs in the parts
bag.)
One screw installed in the rear base. 2.
To Next Page
Loading...
