22
Installation recess
The refrigerator must be installed draught-free in a recess.
The measurements of the recess are given in the table below.
Step (A) is only required for cabinets with a step. Push the appliance far enough into
the recess until the front edge of the refrigerator casing is flush with the front of the
recess. Allow a gap of 15-20 mm between the back wall of the recess and the
refrigeration unit. The floor of the recess must be level, allowing the appliance to be
pushed easily into its correct position. The floor must be substantial enough to bear the
weight of the appliance.
Ensure that the refrigerator is installed level in the recess.
Recess measurements:
Model Hight H Width W Depth T Heigh HSt Depth TSt
RM 6275 825 mm 490 mm 515 mm 220 mm 235 mm
RM 6295 825 mm 529 mm 515 mm 220 mm 235 mm
RM 6365 825 mm 490 mm 515 mm - -
RM 6405 825 mm 529 mm 515 mm - -
6.6
Width of recess = W
Width of recess = W
To Next Page
Loading...
