Glue the mounting frame to the vehicle wall, e.g. with double-sided adhesive tape.
Insert the window from the outside in the center of the wall section.
Press the window slightly so that the packing compound spreads out.
Fasten the window using the fastening bolts and the appropriate securing clips.
Assemble the top mounting brackets first. Always attach the mounting brackets from the center of the frame to
the outside.
NOTE
If a window frame guide rail does not fit evenly against the vehicle wall, then you must use more clips, where
required, than are specified in the table.
Remove the protective film from both sides of the window glass.
After installing, check the wall window works properly.
Using the window
Using S7P
Opening the window (fig.7)
Proceed as follows for each rotary bolt: Turn the rotary bolt by 90°.tary
Tilt the window pane outwards to the desired opening angle.
Closing the window (fig.7)
Close the window slowly.
Proceed as follows for each rotary bolt: Turn the rotary bolt by 90°.
Maintaining and cleaning the window
NOTICE!
Do not use sharp or hard objects for cleaning as these may damage the window glass.
Only use cleaning agents that are approved by the manufacturer. Acrylic glass polish (item no. 9600000128), special
polishing cloth (item no.9600000130) and acrylic glass cleaning agent (item no.9600000129).
Put talcum powder on the rubber seal.
Warranty
The statutory warranty period applies. If the product is defective, please contact the service partner in your country
(see dometic.com/dealer).
Our experts will be happy to help you and will discuss the warranty process with you in more detail.
Disposal
Place the packaging material in the appropriate recycling waste bins wherever possible.
If you wish to finally dispose of the product, ask your local recycling center or specialist dealer for details about
how to do this in accordance with the applicable disposal regulations.
Technical data
To Next Page
Loading...
