iii
ii
During use
After use
Maintenance
Prior to every use
1. Check Fluid level in highest helm pump (refer to your steering
cylinder manual for proper uid level setting).
2.
Verify immediate steering response when turning steering wheel(s).
(Ensure engine turns when steering wheel is turned.)
3. Visually inspect all steering hoses and ttings for wear, kinking
and/or leaks.
4. Check for binding, loose, worn or leaking steering components.
DO NOT OPERATE BOAT IF ANY COMPONENT IS NOT IN PROPER
WORKING CONDITION.
1. WEAR A COAST GUARD-APPROVED PERSONAL FLOTATION
DEVICE (PFD).
2. ATTACH ENGINE SHUT-OFF CORD (LANYARD) TO YOUR PDF.
3. Never allow anyone not familiar with the operation of the
steering system operate the boat at any time.
4. Know and adhere to the operator restrictions for your area
including;
- Federal Laws/Regulations,
- State Laws/Regulations and
- Municipal Laws/Regulations.
DO NOT OPERATE BOAT IF ANY COMPONENT IS NOT IN PROPER
WORKING CONDITION.
1.
Rinse off steering system thoroughly using 'fresh, clean water only'.
- Cleaning uids containing ammonia, acids or any other corrosive
ingredients MUST NOT be used for cleaning any part of the
hydraulic steering system.
1.
Maintain steering system at a minimum of twice per year.
- See Maintenance section
in your steering cylinder manual
.
Keep our waters clean for all current and future users. Dispose of
ALL uids in accordance with your local regulations.
Safety Information Continued
The safety information provided below is intended to inform you of the
dangers that may be present before, during and after use. It is critical
that you read and understand ALL the points noted.
WARNING
To Next Page
Loading...
