Dometic StarLight Installing the device
15
7.3 Connecting the device to the gas supply
!
WARNING! Beware of injury
This device may only be connected to the gas supply by a spe-
cialist in accordance with the applicable guidelines and stand-
ards (in particular EN 1949).
Only use propane or butane gas cylinders with an approved
pressure reducing valve and a suitable head. Compare the
pressure information on the type plate with the pressure infor-
mation on the propane or butane gas cylinder.
Observe the following instructions during connection:
Use gas pipes made from steel 8 x 1 mm (welded, seamless or stain-
less steel), which are flush-mounted with a cutting ring screw assembly.
Fasten the pipes on the side or rear wall of the surrounding furniture parts
so that no loads are exerted on the actuators.
The connection must only be able to be released using tools. Observe the
technical regulations on DVGW worksheets G607 and G608.
The entire pipe system must be free of stress.
During operation, there must be air vents with a cross-section of at least
150 cm
2
in the installation space. These vents can be closed, but must be
kept open when the device is in use.
Connect the device to the gas supply.
➤ Attach a sign above the device with the following text:
“WARNING!
When cooking, provide additional ventilation e.g. by opening windows
near the grill, hob or oven.
This device must not be used for heating the room.”
➤ Open the main shut-off valve.
!
WARNING! Beware of injury
Never check for leaks with a naked flame or near sources of igni-
tion.
➤ Check all connections with leak spray.
There are no leaks if no bubbles form.
To Next Page
Loading...
Need help?
General
