14
Technical performance and characteristics of the motor
• Rated voltage: 12 VDC Power: 20 W
• Wireless remote control
• The erection and dismantling of the tent takes about 50 seconds.
• Motors equipped with overheat protection.
Tips and tricks
• Always ensure the tent is dry before packing away.
• Keep the rail of base clean.
• Ensure ladder is always locked into place and angled away from vehicle.
• Pack the tent down well when driving.
Important information
If your roof tent will not open using the push rods, replace the motor push rods with the sup-
plied two spare poles:
1. Use suitably sized hex key and wrench to
remove motor push rods from both sides.
2. Take the two 92 cm spare poles from the
pocket at the bottom side of the tent.
3. Insert the spare poles instead of the motor
push rods.
Maintenance
• Care for seams and zippers with suitable care products.
• Always ensure good ventilation to avoid moisture.
• Use only lukewarm water and a so brush for cleaning.
• Avoid chemicals, soap and detergents.
• When folding down and covering the tent, make sure the tent is dry.
• If the aluminum frame contains water, erect it to pour out the water.
• Keep the push rod of the motorize pushing rod clean by wiping it with a clean dry cloth.
To Next Page
Loading...
Need help?
General