23
Speed: This function indicates estimated speed, either in km/h or mph,
depending on the position of the switch at the rear of the product (see
diagram)
Distance: This function indicates estimated distance since the beginning
of the exercise session.
This can be in km (kilometres) or M (miles) depending on the position of the
switch on the rear of the product.
Time: This function indicates the length of time since the start of the exercise
session in minutes and seconds (MM:SS) for the first hour, and then in hours
and minutes (HH:MM)
Calories : This function displays an estimation of calories expended since
the beginning of the exercise session.
RPM (Rhythm per minute): Number of pedal rotations per minute
Body fat percentage: Measurement of body fat percentage
Heart Rate*: Your heart rate is measured by the heart strap. It is displayed
in beats per minute.
*Warning: il s’agit d’une estimation, qui ne doit en aucun cas être prise
comme caution médicale.
*Warning: For a period of around 30-40 seconds, or when there is a
change in heart rate, the value displayed may not correspond to your actual
heart rate. This is due to the mechanism starting up.
*Caution: When the product encounters a strong electromagnetic
field, the pulse value maybe displayed or changed.
FUNCTIONS
CONTROLS AT THE BACK OF THE CONSOLE
Switch 1: Selection of type of apparatus that you are using
with the console: VM (magnetic bike) ---- VE (elliptical bike)
Switch 2: Selection of unit of DISTANCE measurement.
MI (Miles) ---- KM (Kilometres)
Switch 3: Selection of geographical region where apparatus
will be used: EU (Europe) ---- AS (Asia)
SWITCH 1
SWITCH 2
SWITCH 3
DIS connections
RESET
ENGLISH
Emitter
1. Parts and components
HEART RATE MONITOR BELT
Flexible belt Lithium battery CR2032, 3V Waterproof seal Battery compartment lid
2. Inserting the battery
• Insert the supplied CR2032 battery as illustrated below.
• First, insert the battery with the + pole towards the top.
• Place the seal and then the lid, with the two small dots aligned.
Tighten with a coin.
Important!
Make sure that the lid is tightly closed (around 1/2 turn) to prevent
perspiration or water from entering.
3. Using the belt
• Before placing the emitter on your chest, moisten the two electro-
des with water or a water-based gel to ensure optimal
transmission of the signal
• Center the heart rate monitor belt on your chest
or pectoral muscles, directly above your sternum,
with the battery compartment lid facing inwards.
• Adjust the belt so that the emitter always stays in close contact
with your skin. Do not overtighten, to avoid breathing diffi culties.
• If the heart-rate monitor belt is loose or positioned incorrectly, you
may get an erroneous or irregular reading.
To Next Page
Loading...
Need help?
General
