Doogee S88Pro - Battery and Electrical Safety Testing; Classification of Electrical Energy Sources

- Page 50 of 60 -
Report No. STS200421001001E
EN 62368-1
Clause Requirement + Test Result - Remark Verdict
Shenzhen NTEK Testing Technology Co., Ltd
Supply voltage ............................................................. : -- —
Location Test conditions specified in 6.1 of
IEC 60990 or Fault Condition No
in IEC 60990 clause 6.2.2.1
through 6.2.2.8, except for 6.2.2.7
Touch current
(mA)
Measured to PE 1 N/A
2* N/A
3 N/A
4 N/A
5 N/A
6 N/A
8 N/A
Supplementary Information:
Notes:
[1] Supply voltage is the anticipated maximum Touch Voltage
[2] Earthed neutral conductor [Voltage differences less than 1% or more]
[3] Specify method used for measurement as described in IEC 60990 sub-clause 4.3
[4] IEC60990, sub-clause 6.2.2.7, Fault 7 not applicable.
[5] (*) IEC60990, sub-clause 6.2.2.2 is not applicable if switch or disconnect device (e.g., appliance coupler)
provided.
N: Normal condition, R: Reverse condition.
6.2.2 Table: Electrical power sources (PS) measurements for classification P
Source Description Measurement
Max Power after 3 s Max Power after 5
s*
)
PS Classification
A
&
Battery
pack output
Power (W) : -- --
PS2
(declaration)
V
A
(V) : -- --
I
A
(A) : -- --
B
#
Battery
pack output
(B- to P-
short circuit)
Power (W) : -- --
PS2
(declaration)
V
A
(V) : -- --
I
A
(A) :
-- --
C
#
Battery cell
Power (W) : -- --
PS2
(declaration)
VA (V) : -- --
IA (A) : -- --