DoorHan RSD02 - Wicket Door Closer Installation

To Next Page

To Previous Page

  59

suPPLEmEnt

If the door leaf has a wicket, the wicket door closer must be installed.

Wicket door closer installation





Main Page

Table of Contents2
Content2
Introduction4
Embrasure Requirements5
Garage Sectional Doors Rsd027
Industrial Sectional Doors Series Isd018
Industrial Sectional Doors Series Isd029
Tools10
Hardware11
Safety Provisions18
Hardware Unpacking20
Installation of Doors20
Bottom Panel Assembling21
Middle Panels Assembling22
Top Panels Assembling23
Vertical Tracks Installation23
Horizontal Tracks Installation25
End U-Shaped Support Brackets Installation26
Cross-Bar Sleeves Installation27
Panels Installation28
Torsion Gear Installation29
Loading of the Spring with Cylindrical Shaft32
Fastening to the Ceiling33
Cable Tension Adjustment35
C-Profile Installation37
Bumper Installation39
Buffer Installation39
Handle Installation40
Catch Installation41
Octagonal Shaft, Spring Loading43
Door Operation43
Supplement43
End Bracket Support Installation44
Door Lock Installation47
Torsion Gear "Spring in Spring49
Installation of Spring Failure Safety Device50
Cable Safety Device51
Cable Break Safety Device52
Installation of Bottom Corner Bracket for Drum Behind53
Installation of Solid Steel Coupler on Octagonal Shaft53
Installation of Bottom Corner Bracket with Cable Tension Device53
Installation of Nonadjustable Coupler for Cylindrical Shaft55
Installation of 31 .75Mm Diameter Shaft55
Manual Chain Operator Installation57
Wicket Door Closer Installation59
Omega-Profile Installation61
Installation of Double Side Supports61
Installation of Halyard Capronic62
Aspects of Vertical and High Lift Installation63
Two-Shaft System on End Support Brackets64
Two-Shaft System on U-Shaped End Support Brackets67
Chain Tension Device Installation68
Mounting of Torsion Gear with Remote Octagonal Shaft70
Aspects of Two-Shaft System of Torsion Gear with Remote Octagonal Shaft Mounting73
Cable Support Installation75
Installation of End Support Bracket at Vertical Lift76
Installation of Bumper at Vertical Lift77
Aspects of Low Lift Mounting77
Roller's Top Support Installation78
Horizontal Track Installation78
Installation of End Support Bracket at Low Lift79
Fastening of Horizontal Tracks to the Ceiling80
Buffer Installation81
Low Lift, Drum from Behind, Pulley Installation82
Low Lift, Drum from Behind, Mounting of Torsion Gear with Octagonal Shaft83
Low Lift, Drum from Behind, Installation of End Support Brackets85
Dismounting87
Upgrading87
Maintenance87
Notes88

DoorHan RSD02 - Wicket Door Closer Installation

Table of Contents

Related product manuals