What to do if my DoorHan SLIDING-1300 Garage Door Opener gate does not open/close fully?
If your DoorHan Garage Door Opener gate isn't fully opening or closing, it might be due to: * Incorrectly adjusted limit switches. Try adjusting the end switches. * The force protection being activated. In this case, adjust the operator's force.
Why my DoorHan Garage Door Opener does not run?
If your DoorHan Garage Door Opener isn't running, here's what to check: * First, ensure that the power to the operator is turned on. * Second, make sure there isn't anything blocking the door's path; remove any obstacles if present. * Third, examine the electrical wires to confirm they are properly connected.
Why does my DoorHan SLIDING-1300 stop suddenly?
If your DoorHan Garage Door Opener stops suddenly, consider these possibilities: 1. The operator's thermal protection might have activated. Allow the operator to cool down. 2. The limit switches or run time might be incorrectly adjusted. Try adjusting their positions.
What to do if DoorHan SLIDING-1300 door does not move after release?
If your DoorHan Garage Door Opener door doesn't move after releasing it, the issue could be that the operator is released, so engage the operator. Alternatively, the door might not be balanced; in that case, adjust the door.
General| Max. door weight | 1300 kg |
|---|---|
| Protection level | IP54 |
| Power supply | 230V AC |
| Operating temperature | -20°C to +50°C |
| Type | Sliding |
| Control options | Remote control |
| Safety features | Obstacle detection |
To Next Page
