DoorHan SMARTROLL User Manual

11
REMOTE CONTROL PROGRAMMING
3.4. REMOTE PROGRAMMING OF CONTROLS WITH DOORHAN MULTI-CHANNEL REMOTE CONTROLS
1. Press the button located on the rear side of the multi-channel control. This button makes the control board enter the re-
mote control recording mode (a short beep will sound, and the “Remote” indicator will light up), provided that the remote
control was previously recorded in the control board.
2. On a new remote control press twice the button, that you wish to operate your rolling shutter. A short beep will sound, the
“Remote” indicator will flash once to confirm the remote control code has been recorded.
NOTES:
 Perform remote control programming within the receiver working range.
 The number of each button can be determined by the number of dots on the remote control body.
1
1
1
1 2
2
2
2
4
4
3
3

DoorHan SMARTROLL Specifications

General

Brand	DoorHan
Model	SMARTROLL
Category	Controller
Language	English