2358-065-L-7-16
1
SECTION 1 - TRACKER EXPANSION BOARD INTRODUCTION 2
1.1 General Information
1.2 General System Layout
1.3 Tracker Expansion Boards Layout Options
1.4 Tracker Expansion Board Overview
1.5 Board Input Descriptions
1.6 Setting Board Address (Software - System Relay)
1.7 Relay Identification (Software - System Relay)
2
3
3
4
5
6
7
SECTION 2 - INSTALLATION 8-9
10
10
11
2.1 Single Board Enclosure
2.2 Quad Board Enclosure
2.3 Single Board Enclosure with Card Reader
11
12
13
14
15
16
17
18
19
20-22
SECTION 3 - HARDWIRING 11
3.1 General HARDwiring Information
3.2 Board Addresses 3-10 Communication Line HARDwiring
3.3 Board Addresses 11-18 Communication Line HARDwiring
3.4 MAX Boards Communication Line HARDwiring
3.5 Basic Board Wiring Options at Access Point
3.6 Alarm Wiring Options at Access Point
3.7 All Available Devices at Access Point
3.8 Typical Dual Mode Wiring at 2 Access Points
3.9 Quad Box Wiring
3.10 Gate Operator Data Wiring - Optional Control Wiring
SECTION 4 - PROGRAMMING 23
4.1 LED and Button Descriptions
4.2 Programming
4.3 Programming Step Descriptions
23
23-25
26-28
SECTION 5 - TROUBLESHOOTING 29
5.1 Wiegand Device Data
5.2 Gate Operator Data
5.3 Gate Operator Event (transaction) Reports
5.4 Complete System Information
29
30
31
32
TABLE OF CONTENTS
DoorKing, Inc. reserves the right to make changes in the products described in this manual without notice and without obligation of DoorKing, Inc. to notify any persons
of any such revisions or changes. Additionally, DoorKing, Inc. makes no representations or warranties with respect to this manual. This manual is copyrighted, all rights
reserved. No portion of this manual may be copied, reproduced, translated, or reduced to any electronic medium without prior written consent from DoorKing, Inc.
To Next Page
Loading...