General Section
40
Mast Abbreviations
The identification plate indicates the type of mast
installed on the lift truck when it left the factory. The
type of mast is indicated by an abbreviation.
STD - Standard Mast(single inner member, low
free lift).
FF - Full Free Mast [single inner member,
with high free duplex or multiple
cylinder(s)].
FFT - Triple Lift Mast (two inner members with
either low or full free lift).
QUAD - Quadruple(Quad) Mast(three inner
members).
SPEC - Special Mast, such as non-telescopic or
double mast, not within the other
classifications.
NOTE: When only a mast-type is listed on the
identification plate, a standard carriage and
forks are used.
Attachment Abbreviations (includes
Special Forks)
SC - Special Carriage-increased width, height
or outreach.
SSS - Shaft-type Sideshift Carriage.
HSS - Hook-type Side Carriage.
ISS - Integral Sideshift Carriage.
ISFP - Integral Shifting type Fork Positioner.
CW - Special Counterweight.
SF - Special Forks.
NOTE: Numbers following this abbreviation indicate
number and/or length of forks.
SS-SWS - Sideshift-Swing Shift.
RAM - Ram or Boom
ROTC - Rotating Carriage.
DBCBH - Double Cube Block Handler
HFP - Hydraulic Fork Positioner, Non Sideshift.
CR - Crane Arm or Crane Boom.
TH - Tire Handler.
CTH - Container Top Handler.
CSH - Container Side Handler
LP - Load Push Device, Non Sideshift.
LPP - Load Push-Pull Device, Non Sideshift.
C -General Clamp (other than Bale, Carton
or Roll).
BC - Bale Clamp.
CC - Carton Clamp.
RC - Roll Clamp.
LS - Load Stabilizer.
LH - Log Handler.
PWH - Pulp Wood Handler.
SS-ST - Sideshift-Side Tilt Carriage.
To Next Page
