Doosan D40S-5 - Drive Axle Oil & Strainer (OCDB Only) - Check, Clean, Change

Maintenance Section
-135-
Drive Axle Oil & Strainer (OCDB
Only) - Check, Clean, Change
WARNING
Hot oil and components can cause personal injury.
Do not allow hot oil or components to contact skin.
Park the lift truck on a level surface. Apply the parking
brake. Place the directional control level in NEUTRAL
and stop the engine.
1. Remove drain plug. Allow the oil to drain into a
suitable container. Clean the magnetic drain plug.
Check O-ring seal and replace if necessary.
2. Install the drain plug.
3. Remove strainer assembly.
4. Washer the strainer assembly in clean,
nonflammable solvent and dry it.
5. Install the strainer assembly and reconnect the hose
and harness.
6. Remove the dip stick/filter cap. Fill the drive axle
housing with oil. See “Lubricant Specification - Drive
Axle Oil” and “Refill Capacity”.
7. Start the lift truck. With the engine at low idle, place
the directional control lever to the NEUTRAL.
8. Maintain the oil level between lower mark and upper
mark on the dip stick/filter cap.
9. Install the dip stick/filter cap.
https://www.forkliftpdfmanuals.com/