OP000753Safety
1-20
Any reinforcement system that is installed on machine must
pass safety and certification standards and carry appropriate
labeling and rating information. For example, most often added
type of reinforcement system, FOPS, must meet or exceed
Society of Automotive Engineers standard SAE J1356,
"Performance Criteria for Falling Object Guards for Wheel
loaders."
Never attempt to alter or modify any type of protective structure
reinforcement system, by drilling holes, welding, remounting or
relocating fasteners. Any serious impact or damage to the
system requires a complete integrity reevaluation.
Reinstallation, recertification and/or replacement of the system
may be necessary.
Install Additional Safety Equipment If
Conditions Require
Laminate glass protection for the front, side or rear windows,
along with tempered glass, may also be recommended
depending upon particular site conditions.
Contact your DOOSAN distributor for available safety guards
and/or recommendations if there is any danger of getting hit by
objects that could strike the operator's cabin. Make sure that all
other work site crew members are kept well away from wheel
loader and safe from potential hazards.
Maintain Standard Safety Equipment in
Good Condition
Machinery guards and body panel covers must be in place at all
times. Keep well clear of rotating parts. Pinch point hazards
such as cooling fan and alternator drive belts could catch hair,
jewelry or oversize or very loose clothing.
Safety labels must be replaced if they are damaged or become
unreadable. Information on labels gives work crew members an
important safety reminder. Part numbers for each decal and
required mounting locations are shown on pages 1-2 through
1-4 of this section.
Attachment Precautions
Option kits are available through your dealer. Contact DOOSAN
for information on available one-way (single-acting) and two-way
(double-acting) piping / valving / auxiliary control kits. Because
DOOSAN cannot anticipate, identify or test all of the
attachments that owners may wish to install on their machines,
please contact DOOSAN for authorization and approval of
attachments, and their compatibility with options kits.
HAOA100L
Figure 11
To Next Page
