SP002667Wheel Loader Safety
Page 22
Seat Belt
Check seat belt daily for correct function.
Inspect seat belt system more often if machine is exposed to
severe environmental conditions or applications. Conduct the
following inspections and replace seat belt system as
necessary:
1. Check webbing. If system is equipped with a retractor, pull
webbing completely out and inspect full length of webbing.
Look for cuts, wear, fraying, dirt and stiffness.
2. Check buckle and latch for correct operation.
3. Make sure latch plate is not excessively worn,
deformed or
buckle is not damaged or casing is broken.
4. Check retractor web storage device (if equipped) by
extending webbing and checking that it spools out and
retracts correctly.
5. Check webbing in areas exposed to ultraviolet (UV) rays
from sun or extreme dust or dirt. If original color of webbing
in these areas is extremely faded and/or webbing is
packed with dirt, webbing strength may be reduced.
NOTE: Contact your DOOSAN distributor for seat belt
system replacement parts.
WARNING
AVOID DEATH OR SERIOUS INJURY
Failure to properly inspect and maintain seat belt and
seat belt system can cause lack of operator restraint
and can result in death or serious injury.
Before fastening seat belt, check that there is no
problem in belt mounting bracket. If it is worn or
damaged, replace seat belt immediately. Fasten seat
belt so it is not twisted.
Always wear seat belt when operating machine.
To Next Page
Loading...
