SP002667
Page 27
Wheel Loader Safety
Be sure to observe these precautions even if a back up alarm or
mirrors are installed.
• Check that back up alarm works properly and that
mirrors are clean, not damaged and properly
adjusted.
• Always latch door and windows of operator's cabin in
position (open or closed).
• On work sites where there is a hazard of flying or
falling objects, or of objects entering operator's cabin,
check that door and windows are securely closed.
Install additional guards, if work site application
requires them.
Never turn starter switch to "O" (OFF) position when traveling.
This can cause a loss of steering control.
Do not operate attachments while traveling.
Never travel over obstacles or excessive slopes that will cause
machine to tilt severely. Avoid any slope or obstacle that can
cause machine to tilt 10° or more to right or left, or 30° or more
from front to rear.
When traveling on rough ground, travel at low speed, and avoid
sudden changes in direction.
Know permitted ground pressure. Ground pressure of the
machine may change depending on attachment and load.
Keep height and length of attachment in mind.
To Next Page
Loading...
