EasyManua.ls Logo

Doosan P1060 - Operating Instructions; Commissioning

Doosan P1060
90 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operating & Maintenance Manual Operating Instructions
32 Book: 22846471 (3-09-07) Rev. B
Operating Instructions
Commissioning
Upon receipt of the unit, and prior to putting it into service, it is important to adhere strictly to
the instructions given below in PRIOR TO STARTING.
Ensure that the operator reads and understands the decals and consults the manuals before
maintenance or operation.
Ensure that the position of the emergency stop device is known and recognised by its
markings. Ensure that it is functioning correctly and that the method of operation is known.
Before towing the unit, ensure that the tire pressures are correct (refer to the GENERAL
INFORMATION section of this manual) and that the handbrake is functioning correctly (refer
to the MAINTENANCE section of this manual). Before towing the unit ensure that the lights
are functioning correctly (where fitted).
Ensure that all transport and packing materials are discarded.
Ensure that the correct fork lift truck slots or marked lifting / tie down points are used whenever
the machine is lifted or transported.
When selecting the working position of the machine ensure that there is sufficient clearance
for ventilation and exhaust requirements, observing any specified minimum dimensions (to
walls, floors etc.).
Adequate clearance needs to be allowed around and above the machine to permit safe access
for specified maintenance tasks.
Ensure that the machine is positioned securely and on a stable foundation. Any risk of
movement should be removed by suitable means, especially to avoid strain on any rigid
discharge piping.
Attach the battery cables to the battery(s) ensuring that they are tightened securely. Attach the
negative cable before attaching the positive cable
WARNING
!
All air pressure equipment installed in or connected to the machine must
have safe working pressure ratings of at least the machine rated
pressure, and materials compatible with the compressor lubricant (refer
to the GENERAL INFORMATION section).
Book:46623600 (10-12-2012) Rev. A

Table of Contents