DONNING INSTRUCTIONS
MUST BE FOLLOWED EACH TIME THE RESPIRATOR IS WORN
Perform hand hygiene using hand
sanitizer or soap and water.
Inspect the assembled respirator prior
to use to assure there are no holes in
the breathing zone and no damage has
occurred. Discard and replace if
damaged.
Cup the respirator in your hand, with the
nosepiece at your fingertips, allowing
the head strap to hang freely below your
hand (Fig. 7).
With the nosepiece up, place the
respirator over your nose and mouth.
Pull the top strap over your head, resting
it high at the top back of your head (Fig.
8).
Adjust the strap length through the
eyelets so that the respirator
comfortably covers both your mouth
and nose (Fig. 9).
Fasten the clips behind your neck (Fig.
10) and pull the loose strap ends to
tighten to an appropriate tension (Fig.
11).
Perform a user seal check each time you
put on the respirator. Use one or both
hands to completely cover the respirator
filter (Fig. 12), and exhale. The respirator
should budge slightly. If air leaks at the
respirator edges, reposition the
respirator on face (Fig. 13) and/or
readjust tension of head strap to
eliminate the leakage. Once the seal
check is successful, the respirator is
ready for use (Fig. 14).
1.
2.
3.
4.
5.
6.
7.
ALWAYS PUT ON DECONTAMINATED RESPIRATOR WITH CLEAN HANDS
WARNING: If you CANNOT achieve proper seal, DO NOT USE
AND SEE YOUR SUPERVISOR.
Fig. 7 Fig. 8
Fig. 9 Fig. 10
Fig. 11 Fig. 12
Fig. 13 Fig. 14
To Next Page
Loading...
