dormakaba USA Inc. | Reset Box User Guide 7039.0521
Introduction
The LA GARD Reset Box removes all Users and resets the Master Password on LA GARD safe locks. The Reset
Box will only work in conjunction with LA GARD electronic safe locks with BAT ports (will not work with older
model LG BASIC Series locks without a BAT port).
Connect the Reset Box
Once the Reset Box is connected to a safe lock, deleted users cannot be recovered. All settings will be
restored to the default values. All Users, except for Master, will be deleted. The Combination for the
Master User will be reset to the default value of 12345678. While the Reset Box is connected to the lock,
ALL communication from the Keypad is rejected. Access to the secured area MUST be maintained (keep
the access door open) until the Reset Box is disconnected from the lock. If the access door is closed, the
lock will have to be drilled to re-open.
Follow these steps to connect a Reset Box to a LA GARD safe lock:
1. Disconnect the safe lock from all power sources. The safe lock should also be disconnected from any
Keypad or Multiplexer prior to connecting the Reset Box.
2. Insert batteries into the Reset Box.
3. Connect the Reset Box to the safe lock BAT port.
4. The LED will illuminate and then stop when reset is complete. Do NOT unplug the box before the reset is
complete.
5. Disconnect the Reset Box from the safe lock.
6. Once successfully reset, the Master Password will be reset to 12345678.
7. Reconnect the safe lock to the system.
Specifications
Battery
2 x 9V DC alkaline batteries (Eveready™ or Duracell™ strongly preferred)
Cables
1 x 43109-3 cable
Environmental
Operating & Storage Temperature Range: 32 – 122 °F (0 – 50 °C)
Relative Humidity Range: 0 – 95% non-condensing
To Previous Page
Loading...
