Doro 2710 - Page 44

English
When you take your phone abroad, you can keep it in flight mode. If you
do that, there’s no chance of data roaming charges. Enable Flight mode
when in areas with no network coverage to save battery since the phone
repeatedly scans for available networks and this consumes power. You can
be notified by alarms, if alarms are activated.
1. Press Menu Settings Connections Flight mode.
2. Press On to activate it. Press Off to deactivate.
Network account
The network account has the Access Point Name (APN) which is the name
of a gateway between a mobile network and another computer network,
mostly the public Internet. The APN settings are used by services that com-
municates using other computer networks. The APN settings for most ma-
jor service providers are already included from start.
Follow the steps below if your service provider’s profile is not in the list or
if you need to change any setting. Contact your service provider for correct
settings.
1. Press Menu Settings Connections Network account:
2. Select your service provider and press to activate that network
account.
3. Press for the following options:
These settings are needed to use the picture messages function. The
settings for picture messages is supplied by your service provider and
can be sent to you automatically.
• New connection: Follow the steps below if your service provider is
not in the list. Contact your service provider for correct settings.
• Name to add account name.
• Username to add user name.
• Password to add password.
• Access point to add APN (Access Point Name).
• Auth type to specify the type of authentication to be used if your
service provider has an APN with user name and password.
• IP type to specify the protocol which the device must use to ac-
cess the Internet, through cellular data.
• Gateway to add a gateway proxy address.
40