Doro 610 - Caller Identification

English
3
Caller Identication
The display shows you who is calling and the 10 most recent missed callers.
New Caller ID is indicated by  in standby mode.
If the same number calls in more than once it will be saved as only one entry.
This function requires a subscription from your service provider.
This telephone will not display the time and date of the call.
Retrieving and Dialling CID Numbers.
1. Repeatedly press  until the required telephone number is displayed.
2. Press q to dial the displayed number, or press C to return to standby mode.
Erasing Numbers
1. Repeatedly press  until the required telephone number is displayed.
2. Press and hold
C
until a beep is heard.
Erasing All Numbers
Press
º
0
5
º
.
Messages
Apart from showing phone numbers, the display may show the following:
No information was received, e.g. international call, secret
or blocked numbers (not stored).
The number is longer than the display size (>12 digits).
Network Voice Mail*.
*Network Voice Mail can be cancelled from the display by pressing
º
0
#
º
.
Settings
1. Press
P
.
2. Press button according to list below, e.g.
4
for handset volume.
3. The display shows current setting, e.g. P-4 2
┘
3 means commando 4, current
setting 2 out of 3.
4. Press corresponding digit for desired setting, e.g.
3
for max.
5. Press
º
toconrm.
Button Function
4
..................................... Handset Volume (1=min....3=max)
5
..................................... Ringer Melody (1=type 1....6=type 6)
6
..................................... Ringer Volume (1=min....3=max)*
9
..................................... Reset (Enter PIN-code, 0000 when supplied)
R
..................................... Recall Button Timing (2=100ms/normal, 6=300ms)
*
..................................... Tone/Pulse Dialling (1=pulse, 2=tone/normal)
*To turn the ringer on/off, in standby press and hold
* (
= ringer off).