10
English
Expanded system (+1)
All handsets included in the package are already registered to the base unit. The handset
number used for internal calls is shown in the display on standby mode.
The base unit should be positioned centrally so that the coverage area is roughly equal for all
handsets. You can register up to 5 handsets to one base unit.
This model is GAP (Generic Access Prole) compatible, which means that the handset
and the base unit can both be used with most other GAP compatible units irrespective
of manufacturer. However the GAP protocol cannot guarantee that all functions may be
accessed.
Intercom / internal call
1. Press Int.
2. Scroll to selected handset. Press OK.
A tone will be heard if an external call comes in while an internal call is in progress. End the
internal call with
L
and then answer the external call with
O
.
Transferring calls/Conference between handsets
1. An external call is connected.
2. Initiate an internal call as described above.
3. Press
L
to transfer the call or press Conf for conference.
Register a new handset
All new handsets that are to use the base unit must be registered.
1. Press Menu. Scroll to Settings. Press OK.
2. Scroll to HS Settings. Press OK.
3. Scroll to Register HS. Press OK.
4. Scroll to the desired base. Press OK.
5. Enter the base unit’s PIN code (0000 on delivery). Press OK.
6. Hold down the base unit’s search button
J
until a beep is heard.
7. If the registration is successful the handset will return to standby mode within one
minute.
To Next Page
Loading...
