Doro 820 - Recall Button Timing; PBX Function

English
16
www.doro.com
16 www.doro.com16
Settings
Recall Button Timing
In some PBX installations, the timing of the Recall button may need to be adjusted.
For normal domestic use, this setting should not require changing.
If the telephone has been purchased in Australia this setting will be displayed as 3/4.
1.
Press
w
.
2.
Scroll using
< <
/
> >
until
w
 ashes in the display. Press
0
0
.
0
3.
Press
0
repeatedly until the display shows 4/5. - UK (3/4 - Australia).
0
repeatedly until the display shows 4/5. - UK (3/4 - Australia).
0
4
.
Scroll using
< <
/
> >
to the desired setting:
= 100ms
=
=
270ms (UK) - 600ms (AU/NZ)
5.
Press
0
to con rm setting and move to the next programming sequence,
0
to con rm setting and move to the next programming sequence,
0
alternatively.
6.
Press
w
to exit the Menu system.
PBX Function
This telephone has a PBX function that will automatically insert a pause between the
 rst and second digits of the telephone number before dialling.
For example:
When the function is activated (see below), dialling a phone number ie: ”0123456”,
the phone will dial: “0” followed by a pause, and then the remaining part of the
number: “123456”.
If the telephone has been purchased in Australia this setting will be displayed as 4/4.
1.
Press
w
.
2.
Scroll using
< <
/
> >
until
w
 ashes in the display. Press
0
0
.
0
3.
Press
0
repeatedly until the display shows 5/5. - UK (4/4 - Australia).
0
repeatedly until the display shows 5/5. - UK (4/4 - Australia).
0
4.
Scroll using
< <
/
> >
to the desired setting (YES=on, NO=off). Press
0
to
con rm.
5.
Press
w
to exit the Menu system.