Doro Sara - Installation and Connection; Telephone Line Setup

7
Doro Sara
INSTALLATION
Connection
The carephone is very easy to install, connection to the telephone network is
via the telephone lead/adapter.
The carephone should be connected to the master telephone socket in the
home in order for it to continue to work even if a telephone receiver is left
off the hook or is faulty. The master socket is normally the one closest to the
entrance door – for further advice, contact your supplier.
Power is supplied via the power supply from a wall socket.
1. Disconnect the existing telephone from the telephone jack and connect
the telephone lead/adapter to the jack. Connect the telephone lead to
the TEL socket on the carephone.
2. Connect the power supply to the wall socket and the power supply lead
to the POWER socket on the carephone.
3. Turn the power switch to the ON position. Check that the indicator
lamp has a steady green light.
4. Connect the existing telephone to the intermediate plug. Lift the receiver
and check that you can hear the tone.
5. Carry out a test alarm from the carephone.