9
Doro Sara
PROGRAMMING
The carephone’s telephone numbers, alarm codes and settings are
programmed via a computer, using the programming cable and the Doro
software.
For help with programming and information about other programming tools,
please refer to the carephone’s service manual or contact your supplier.
In some cases, the carephone can be delivered ready-programmed by the
supplier.
Program the radio triggers
Up to nine radio triggers or other radio-alarm transmitters, e.g. smoke
detectors, can be programmed with the carephone.
1. Hold down the green button for approximately four seconds until light
starts to ash green.
2. Press the radio trigger. Once the carephone has received the radio
signal, you will hear a distinct tone signal.
3. Conrm by pressing the red button on the carephone.
Check the radio coverage
Always check the function after installation and programming.
• Hold down the green button for approximately four seconds until the
green light starts to ash.
• Press the radio trigger. The built-in speaker will produce a tone signal
on successful reception. Repeat this in all areas where the alarm
needs to operate.
Check the functionality
Always check the function after installation and programming. Test alarms
shall be done regularly and in a way that secures the whole alarm chain
from radio transmitter to alarm receiver.
To Next Page
Loading...