Receiving
You should inspect the grinder immediately after you receive delivery.
See the “Machine Component Identification” section of this
manual for a diagram of the grinder and its components.
If you have missing components, contact your rental company or Dosko
Customer Service at 1-763-428-2237.
Depending on your unit and model, it may have been shipped on a wooden skid,
cardboard container or other appropriate method.
For any shipping damage, make sure the delivery driver acknowledges it and a
claim is filed with the freight delivery company.
Note: Shipping damage claims are not covered by Dosko warranty.
Please contact carrier!
If any assembly is required. Separate assembly instructions will be included.
Your unit should have been delivered completely assembled and ready to run.
Read the “Operation: Pre-Start Check List & Procedures” section (page 9), and
verify that the unit has been properly “prepped” before initial use.
In these cases, your unit has been completely assembled, tested and pre-run.
It should be ready for usage. See “Pre-Start Check List & Procedures”.
To Next Page
Loading...
