Reference Manual 24
• Modem On/Switch: Once activated, you can manually connect/
disconnect the Internet connection by toggling the On/Off switch,
located at the back of your 3GN. Note: This switch only works for
the inserted USB modem, and not the Ethernet WAN port.“
The following scenarios should assist you in enabling your 3GN for
Internet access, depending on which type of USB modem you have
inserted into the 3GN.
If your scenario is not available in this guide, then please visit
www.dovado.com/support for latest update.
Once the information has been inserted, the unit will automatically try
to establish a connection to the operator’s network. A solid yellow light
on the USB LED indicates a successful connection.
Note: Mobile operators typically have an Access Point Name (APN) as
the key relevant point of entry towards the mobile broadband network.
Make sure to have the name of your APN in advance of confi guring
your USB modem. If you are using any other technology besides GPRS,
EDGE, UMTS or HSPA, you might not require an APN.
Scenario 1: 3G USB modem using a SIM card
•
In the Modem->Modem Settings page, select to use SIM.
• Enter your operator Access Point Name and a PIN code if using one.
• Push Save Modem Settings.
• Restart the 3GN.
Scenario 2: 3G USB modem using a SIM card along with a username
and password
•
In the Modem->Modem Settings page, select to use SIM.
• Enter your operator Access Point Name and a PIN code if using one.
• Push Save Modem Settings.
• Go to Modem->PPP and make sure that PPP is enabled.
• Enter your Username and Password
• Save PPP Settings
.
• Restart the 3GN.
8388 3GN manual hopslagn.indd Avs1:158388 3GN manual hopslagn.indd Avs1:15 2010-01-04 14.092010-01-04 14.09
To Next Page
Loading...
