Advanced settings 36
LAN Settings
LAN->LAN Settings: The network settings for the 3GN.
Network Settings allows you to change the default IP address for your
3GN. However, in most cases you do not need to change this setting.
Note that the IP address for the 3GN is used on your private network
only. It is not possible to change the subnet mask. Click on
Save LAN
Settings
and then Restart for the changes to take effect.
LAN->DHCP: The settings for your private network.
DHCP Server
allows you to enable or disable the built-in DHCP server.
When enabled, all clients on your private network will automatically
obtain an IP address from the range specifi ed under
Client IP Address
Range
(valid range is from 1 to 254). When disabled you have to
manually enter an IP address from this range into each client.
Client Network Information allows you to set a domain name for the
3GN and specify an additional DNS server.
Static Address Assignment can be used when you want a client to
obtain the same IP address each time it logs on to your private network.
This setting works no matter if the DHCP Server is enabled or disabled.
Select how you want to identify the client, by hostname or MAC
address (it is possible to defi ne 253 static IP addresses based on MAC
addresses and 256 based on hostnames). Type in the hostname or the
MAC address under
Host Identifi er and fi nally, set the desired IP address
under
Internal Address. Please make sure not to assign the IP address
of the 3GN to any of the clients. Click on Add and then
Save DHCP
Settings
when you are fi nished.
View DHCP Table is a function that shows the IP and MAC addresses of
all clients that are connected to the 3GN.
8388 3GN manual hopslagn.indd Avs1:288388 3GN manual hopslagn.indd Avs1:28 2010-01-04 14.092010-01-04 14.09
To Next Page
Loading...
