SECTION 4 CLEANING AND CARE
0855849enf 6/08 53
1.2 Jet Testing
CAUTION. Hot Surfaces. To prevent injury from burns, be careful
not to touch the jet array surface or hot ink directly. Wear
protective eyeglasses when working with hot ink.
1. Press and hold the Jet Test button while moving a piece of paper
approximately 6mm (1/4") from the front of the jet array.
2. Examine the test pattern to confirm proper jet operation.
3. If any jets are not working properly, repeat the Purge and Jet
Test procedures. DO NOT WIPE the jet array unless several
attempts at purging are unsuccessful in recovering jets.
To Next Page
Loading...
