Need help?Do you have a question about the Dover Markem-Imaje 5200 and is the answer not in the manual?
General| Technology | Thermal Transfer |
|---|---|
| Print Resolution | 300 dpi |
| Maximum Print Speed (Intermittent) | 300 mm/s |
| Maximum Print Speed (Continuous) | 500 mm/s |
| Supply Voltage | 100 – 240 VAC |
| Print Speed | Up to 500 mm/s |
| Ink Type | Thermal Transfer Ribbon |
| Connectivity | Ethernet, USB |
Introduction to the Model 5200/5400 case coders and their technology.
Overview of the guide's content and topics covered.
List of other relevant documents in the 5200/5400 documentation set.
Prerequisites and assumptions before operating the coder.
Definitions of technical terms used in the operation guide.
Information and warnings regarding safe operation and potential hazards.
Detailed explanation of labels and symbols found on the coder.
Step-by-step instructions for safely removing the coder from operation.
Identifies and describes the main parts of the coder system.
Location and operation of the main power switch for the coder.
Procedure for safely shutting down and powering off the coder.
Overview of the display, keypad, and indicator lights.
Explanation of the status, ink, and fault LED indicators.
How to navigate through menus using the keypad.
Explanation of the F1-F4 function keys and their uses.
Functionality of the ENTER and EXIT keys for menu interaction.
Operation of the START and STOP keys for printing control.
How to use an optional external keyboard with the coder.
Description of the printhead and its components.
Operation of the Jet Test and Purge buttons on the printhead.
Interpreting the printhead status LED.
Procedure for powering on the coder and initial startup.
Information displayed on the Top Level menu.
Steps to select a print job from the available list.
How to preview a print job image before selection.
Conditions and steps required to start production printing.
Procedures for adding ink bottles or ink blocks to the coder.
Instructions for inserting ink blocks into the coder.
Procedures for adjusting coder settings.
How to adjust the brightness and darkness of the LCD display.
Adjusting print registration for accurate image placement.
Managing job files and data on the host computer and coder.
Procedures for daily cleaning to maintain printhead quality.
How to perform the purging procedure for the jet array.
Procedure for testing jet operation and print quality.
Guidelines for wiping the printhead jet array.
General instructions for cleaning the coder and its components.
General advice for troubleshooting and seeking assistance.
How to use LED indicators and signal tower lights for diagnostics.
Correlating signal tower lights with coder status.
Interpreting the LED indicator on the printhead.
Troubleshooting issues with the LCD display contrast.
Explanation and resolution for beeps from an open ink door.
Troubleshooting why the purge button might not work.
To Next Page
