SECTION 3 PRINTING
0855849enf 6/08 35
1.0 Powering on the Coder
1. Turn the power switch (1) to the I position to power on the coder.
• The green STATUS LED (2) begins blinking.
• The amber LED on the printhead begins blinking.
• The Version Menu appears briefly.
• The Top Level menu appears.
2. The status message will say Warming up or Shut Down.
If the status message indicates the coder is shut down, the start
up process can be initiated by pressing F3 (Start Up).
A prompt will ask you to confirm that you want to start up.
Select YES.
3. Wait for the blinking green STATUS LED to begin to blink slowly.
It takes about 60 minutes for the ink delivery module and ink
lines to warm up and for the coder to be ready for printing. It
could take longer in colder environments or if the supplied
voltage is low.
25 Jun 2006 15:17:49
Status
Machine: Ready PH1:On
State: Offline PH2:On
Ink: OK
Counts:
Batch : 999
Total : 53796
- Press ENTER to preview image -
Job: Chocolate
Job
Select
Reg.
+ / -
Main
Menu
Shutdown
To Next Page
Loading...
Need help?
General