SECTION 1 GENERAL INFORMATION
0855849enf 6/08 17
1.0 Removal from Service
Follow these instructions to remove the coder from service. These
instructions also pertain to transporting or storing the coder.
1. Use the Shutdown menu to cool down and power off the coder.
2. Disconnect the AC power cord from the electrical source.
3. Disconnect cables and connections, accessed from the I/O door.
4. Disconnect the umbilical lines from the printhead and the
enclosure.
5. Remove the signal tower, carton sensor, and encoder, if
applicable.
6. Remove each printhead from its mounting assembly.
7. Move the enclosure to the desired location, and package the
enclosure, printhead(s), and cables in the original shipping
container.