SECTION 1 GENERAL INFORMATION
0855849enf 6/08 11
4.3 Safety Labels
High Voltage
To prevent injury from electrical shock, remove the power cord from
the electrical outlet before performing troubleshooting or repair.
Electronic troubleshooting must be performed by personnel trained to
troubleshoot electrical circuits.
Hot Surfaces
To prevent injury from burns, be careful not to touch the jet array
surface or hot ink directly. Wear protective eyeglasses when working
with hot ink.
Protective Earth
This label identifies a protective earth point.
Earth
This label identifies an earth point.
4.4 Location of Safety Labels
REAR
FRONT
To Next Page
Loading...
Need help?
General