You can press any button other than the SNZ/LIGHT button to turn off
the alarm.
Alarm will go off in the way shown as below.
0-10s: 1 beep/second
11-20s: 2 beeps/second
21-30s: 3 beeps/second
After 30s, the alarm will keep beeping for 4 times until you stop the
alarm.
Press “ALARM” button to confirm your setting and the Minute icon of
Alarm 2 starts to flash. Use “+/CH” and “-/C/F” buttons to set the
desired minute.
Press “ALARM” button to confirm your setting and the Repeat icon
starts to flash. Use “+/CH” and “-/C/F” buttons to set the repeat mode
of Alarm 2: M-F or S-S or M-F and S-S.
Press “ALARM” button to confirm your setting, the Snooze Time (5
min-60 min) icon starts to flash. Use “+/CH” and “-/C/F” buttons to set
the desired snooze time for Alarm 2.
Press “ALARM” (or you can wait for 30s without further operation) to
save the setting and get out of the alarm setting mode.
You can press SNZ/LIGHT button to exit the setting mode as well to
be back inthe time display mode.
When the ALARM1 switch is turned ON, the ALARM 1 is activated
and the icon “ ” will appear on the screen.
When the ALARM1 switch is turned OFF, the ALARM 1 is deactivated
and the icon “ ” will disappear. The operation applies to the ALARM
2 switch as well.
Alarm and Snooze
While the alarm is beeping, the alarm icon will flash on the screen as
well. It will stop automatically after 2 minutes.
While the alarm is beeping, press the “SNZ/LIGHT” to enter the
snooze mode. The alarm will beep again after the snooze timer
expires.
- 10 -
To Next Page
Loading...