Time setting mode
Press "SET" button to confirm your setting and the Year icon starts to
flash. Use “+/CH” and “-/C/F” buttons to set the correct year.
During the searching, the MSF icon flashes while the screen and
the projection turn off. It takes about 3 minutes to complete the
procedure and get the time set automatically. When the calibration
completes, the MSF icon changes from to .
The clock will automatically search for MSF signals everyday at 1:00,
2:00, 3:00, 4:00, 5:00 a.m. (compulsory reception during 1:00-3:00
a.m.; alternative reception during 4:00-5:00 a.m.).
Press and hold the -/C/F button again to end the searching manually.
If the clock fails to receive the MSF signal, press and hold the -/C/F
button for approx. 3s to start the searching manually.
Press and hold down the "SET" button for 3 seconds and the MSF
ON/OFF icon starts to flash. Use “+/CH” and “-/C/F” buttons to turn
on/off Auto Time Calibration.
Press "SET" button to confirm your setting and the DST icon starts to
flash. Use “+/CH” and “-/C/F” buttons to turn on/off DST.
Press and hold down the "SET" button for 3 seconds and the
Language icon starts to flash. Use “+/CH” and “-/C/F” buttons to
choose a desired language. options come as followed: GER, ENG,
ITA, FRE, DUT, SPA, DAN. The default language is GER.
Press "SET" button to confirm your setting, and the 12/24 Hour Mode
icon starts to flash. Use “+/CH” and “-/C/F” buttons to choose 12-hour
/ 24-hour time format.
Press "SET" button to confirm your setting and the Hour icon starts to
flash. Use “+/CH” and “-/C/F” buttons to set the correct hour.
Press "SET" button to confirm your setting and the Minute icon starts
to flash. Use “+/CH” and “-/C/F” buttons to set the correct minute.
Press "SET" button to confirm your setting and the Month icon starts
to flash. Use “+/CH” and “-/C/F” buttons to set the correct month.
- 08 -
To Next Page
Loading...