a. Batteries are only used to save the setting of your clock. Please do
not use batteries as main power supply (you will not be able to
operate the alarm clock when it is only powered by batteries).
Instead, please use the included power adapter.
b. When the backlight is in MI/LO/OFF mode, press the SNZ/LIGHT
button to turn on the backlight for 15s.
c. When the alarm clock is receiving MSF signal, the display will shut
off. If the clock has received the MSF signal successfully or the MSF
signal is not received automatically, the display will light up again.
Backlight
Note:
Projection function
When the weather clock is plugged in using the included adapter, the
backlight will always be on.
Press the SET button to adjust the brightness from High >> Medium
>> Low >> OFF.
When the weather clock is powered by battery only, the backlight will
be off.
In standard mode, press “ ” button to flip projection for 180 degrees.
When the weather clock is plugged in, the projection will stay on. If
you want to change from long-term projection to short-term
projection, switch off the projection and short press SNZ/LIGHT
button. Then, the projection will only light up for 15s.
Two projection mode: time and indoor temperature, time and outdoor
temperature. The alarm clock will take turns displaying indoor and
outdoor temperature every 5s.
Press and hold “ ” button to adjust the brightness levels of projection
light: HI-LO
Rotate the focus knob to adjust the projection for optimal clarity.
- 13 -
To Next Page
Loading...