DR K10 RAPIDFIRE - Page 24

75 MEIGS ROAD, P.O. BOX 25, VERGENNES, VERMONT 05491
©2015 Country Home Products, Inc. All rights reserved 372181
Daily Checklist for the DR K10 RAPIDFIRE LOG SPLITTER
To help maintain your DR K10 RAPIDFIRE LOG SPLITTER for optimum performance, we recommend you follow this checklist
each time you use your Log Splitter.
 Check that motor cooling fins are clean of debris.
 Check the general condition of the Log Splitter, e.g.; Nuts, Bolts, Welds, etc.
 Check the Frame for wear and damage.
 Check the Wedge for nicks and wear. Sharpen if needed.
 Apply a rust preventative (Fluid Film or equivalent) to any bare metal areas on the top of the Rail. This will assure the longest
possible service life of the Wedge.
End of Season and Storage
 Check the Wedge for nicks and wear. Sharpen if needed.
 Apply Grease to the Rack and Pinion Teeth.
 Apply a rust preventative (Fluid Film or equivalent) to any bare metal areas on the top of the Rail.
 Clean the exterior of the unit to remove all dirt, grease, and any other foreign material. Clean dirt and debris from the motor
cooling Fins. To prevent rust, touch up painted surfaces that have been scratched or chipped.
 Be sure all Nuts, Bolts, and Screws are securely fastened.
 If possible, store the Log Splitter in a dry, protected place. If it is necessary to store the Log Splitter outside, cover it with a
protective material (especially the Motor).
Before performing any maintenance procedure or inspection, stop the motor, wait five minutes to allow all parts to cool.
Disconnect the power cord from the source of Electricity.
Before performing any maintenance procedure or inspection, stop the motor, wait five minutes to allow all parts to cool.
Disconnect the power cord from the source of Electricity.