14 DR
®
PILOT™ LEAF and LAWN VACUUM
2. Standing on the right side of the machine, insert the ends of the first
Collector Tube into the corner loops in the Enclosure (Figure 20). Note the
orientation of the DR Logo and top Velcro Flaps.
3. Push the Tubes through until the they stick out the other end approximately
5-1/2" (Figure 21).
4. Flip the Enclosure over (Figure 22) so the other side is facing up (Figure 23).
5. Go to the left hand side of the machine (Figure 24).
6. Insert the ends of the second Collector Tube into the corner loops in
Enclosure.
DR Logo
Collector
Tube
Figure 24
Left Side o
Machine
Loop Opening
at Enclosure
Corner
Velcro
Flaps
Figure 23
Figure 22
Collector
Tube
Figure 21
pproximately
5-1/2"
Collector
Tube
Figure 20
DR Logo
Right Side
o
Machine
Loop Opening
at Enclosure
Corner
Velcro
Flaps