DR PILOT - Page 19

CONTACT US AT w w w .DRpow er.com 19
Note: There are seams sewn along the edges of the Door Panels to create Pockets
that the Battens must be inserted into (Figure 46). This will enhance the
performance of the latching system. One end of the Batten Pocket is open
with an elastic flap concealing the opening. The other end is sewn together to
retain the Batten.
29. Insert the Batten under the Elastic Flap at the corner and push it in a bit
until it hits the seam (Figure 47).
30. Flip the Batten over 180 degrees and push it into the large pocket that runs
the length of the edge and insert it in until it stops at the other end (Figure
48).
31. Pull the Elastic Flap out and over the end of the Batten to secure it. Repeat
for the other three Battens (Figure 49).
32. Secure the top Door to the bottom Door with the three Buckles (Figure 50).
33. Secure the side Doors together with the three Buckles (Figure 51).
Buckles
Figure 51
Left
Side
Right
Side
Buckle
s
Figure 50
Top
Bottom
Secured, No
Batten Showing
Figure 49
Large
Pocket
Figure 48
Batten
Figure 47
Elastic
Flap
Figure 46
Batten
Locations